NETGEAR ProSafe GSM5212P Software Administration Manual page 232

4. Add multicast group 224.1.2.3 to MVR.
a. Select Switching > MVR > Basic > MVR Group Configuration. A screen similar to
the following displays:
b. In the the MVR Group IP field, enter 224.1.2.3.
c. Click Add.
5. Configure a receiver on interface 0/1, 0/5, and 0/7.
a. Select Switching > MVR > Basic > MVR Interface Configuration. A screen similar
to the following displays:
b. Under MVR Interface Configuration, scroll down and select the Interface 0/1, 0/5 and
0/7 check boxes.
c. Enter the following information:
• In the Admin Mode list, select Enable.
• In the Type list, select Receiver.
d. Click Apply to save the settings.
232 | Chapter 14. MVR (Multicast VLAN Registration)
ProSafe Managed Switch