NETGEAR ProSafe GSM5212P Software Administration Manual page 449

ProSafe Managed Switch
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface list, select 1/0/22.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply.
7. Enable RIP on interface 1/0/24.
a. Select Routing > RIP > Advanced > Interface Configuration. A screen similar to
the following displays.
b. In the Interface list, select 1/0/24.
c. For RIP Admin Mode, select the Enable radio button.
d. Click Apply.
8. Enable multicast globally.
Chapter 28. PIM | 449