NETGEAR ProSafe GSM5212P Software Administration Manual page 469

Managed switch 9.0.2

Hide thumbs Also See for ProSafe GSM5212P:

Table of Contents

ProSafe Managed Switch

a. Select Routing > RIP > Advanced > Route Redistribution. A screen similar to the

following displays.

b. In the Source field, select Connected.

c. In the Redistribute Mode field, select Enable.

d. Click Apply to save the settings.

Enable DHCP L3 relay.

a. Select System > Services > DHCP Relay. A screen similar to the following displays.

b. For Admin Mode, select the Enable radio button.

c. Click Apply to save the settings.

Configure the DHCP server IP address.

a. Select System > Services > UDP Relay. A screen similar to the following displays.

b. In the Server Address field, enter 10.100.1.1.

c. In the UDP Port field, enter dhcp.

d. Click Add to save the settings.

Chapter 29. DHCP L2 Relay and L3 Relay