NETGEAR ProSafe GSM5212P Software Administration Manual page 172

command to enable traffic shaping by specifying the maximum transmission bandwidth limit
for all interfaces (Global Config) or for a single interface (Interface Config).
The <bw> value is a percentage that ranges from 0 to 100 in increments of 5. The default
bandwidth value is 0, meaning no upper limit is enforced, which allows the interface to
transmit up to its maximum line rate.
The bw value is independent of any per-queue maximum bandwidth values in effect for the
interface and should be considered as a second-level transmission rate control mechanism
that regulates the output of the entire interface regardless of which queues originate the
outbound traffic.
CLI: Configure traffic-shape
(Netgear Switch) (Config)#traffic-shape?
<bw>
(Netgear Switch) (Config)#traffic-shape 70?
<cr>
(Netgear Switch) (Config)#traffic-shape 70
(Netgear Switch) (Config)#
Web Interface: Configure Traffic Shaping
1. Set the shaping bandwidth percentage to 70 percent.
a. Select QoS > CoS > Advanced > CoS Interface Configuration. A screen similar to
the following displays.
b. Under CoS Interface Configuration, scroll down and select the interface 1/0/3 check
box. Now 1/0/3 appears in the Interface field at the top.
c. In the Interface Shaping Rate (0 to 100) field, enter 70.
d. Click Apply to save the settings.
172 | Chapter 11. CoS Queuing
Enter the shaping bandwidth percentage from 0 to 100
in increments of 5.
Press Enter to execute the command.
ProSafe Managed Switch