Mld Snooping - NETGEAR ProSafe GSM5212P Software Administration Manual
Managed switch 9.0.2
Hide thumbs
Also See for ProSafe GSM5212P:
- Software setup manual (36 pages) ,
- Hardware installation manual (28 pages) ,
- Installation manual (2 pages)
Table of Contents
Advertisement
a. Select Routing > IPv6 Multicast > MLD > Global Configuration. A screen similar to
the following displays.
b. For Admin Mode, select the Enable radio button.
c. Click Apply.
12.
Enable MLD on interface 1/0/24.
a. Select Routing > IPv6 Multicast > MLD > Routing Interface Configuration. A
screen similar to the following displays.
b. Under MLD Routing Interface Configuration, scroll down and select the 1/0/24 check
box. Now 1/0/24 appears in the Interface field at the top.
c. In the Admin Mode field, select Enable.
d. Click Apply.
MLD Snooping
In IPv4, Layer 2 switches can use IGMP snooping to limit the flooding of multicast traffic by
dynamically configuring Layer 2 interfaces so that multicast traffic is forwarded to only those
interfaces associated with IP multicast address. In IPv6, MLD snooping performs a similar
function. With MLD snooping, IPv6 multicast data is selectively forwarded to a list of ports
that want to receive the data, instead of being flooded to all ports in a VLAN. This list is
constructed by snooping IPv6 multicast control packets.
484 |
Chapter 30. MLD
ProSafe Managed Switch
Advertisement
Table of Contents
