NETGEAR ProSafe GSM5212P Software Administration Manual page 340

CLI: Configure SNMP V3
(Netgear Switch) #config
(Netgear Switch) (Config)#users passwd admin
Enter old password:
Enter new password:12345678
Confirm new password:12345678
Password Changed!
change the password to "12345678"
(Netgear Switch) (Config)#users snmpv3 authentication admin md5
Set the authentication mode to md5
(Netgear Switch) (Config)#users snmpv3 encryption admin des 12345678
Set the encryption mode to des and the key is "12345678"
Web Interface: Configure SNMP V3
1. Change the user password.
If you set the authentication mode to MD5, you must make the length of password longer
than 8 characters.
a. Select Security > Management Security > User Configuration > User
Management. A screen similar to the following displays.
b. Under User Management, scroll down and select the User Name admin check box.
Now admin appears in the User Name field at the top.
c. In the Password field, enter 12345678.
d. In the Confirm Password field, enter 12345678.
e. Click Apply to save the settings.
2. Configure the SNMP V3 user.
340 | Chapter 20. SNMP
ProSafe Managed Switch