NETGEAR ProSafe GSM5212P Software Administration Manual page 46

Web Interface: Add a Static Route
1. Select Routing > Routing Table > Basic > Route Configuration to display the Route
Configuration screen.
2. In the Route Type list, select Static.
3. Fill in the Network Address field. Note that this field ishould have a network IP address, not
a host IP address. Do not enter something like 10,100.100.1. The last number should
always be 0 (zero).
4. In the Subnet Mask field, enter a value that matches the subnet range that you want to use.
5. The Preference field is optional. A value of 1 is entered by default if you do not enter a
number.
6. Click the Add button on the bottom of the screen. The screen is updated with the static route
shown in the routing table.
7. To remove a route entry, either static or default, select the check box to the left of the entry,
and click the Delete button on the bottom of the screen.
46 | Chapter 4. Port Routing
ProSafe Managed Switch