Set Classofservice Trust Mode - NETGEAR ProSafe GSM5212P Software Administration Manual

ProSafe Managed Switch
Web Interface: Show classofservice Trust
Select QoS > CoS > Basic > CoS Configuration. A screen similar to the following displays.

Set classofservice Trust Mode

The example is shown as CLI commands and as a Web interface procedure.
CLI: Set classofservice Trust Mode
(Netgear Switch) (Config)#classofservice?
dot1p-mapping
ip-dscp-mapping
trust
(Netgear Switch) (Config)#classofservice trust?
dot1p
ip-dscp
(Netgear Switch) (Config)#classofservice trust dot1p?
<cr>
(Netgear Switch) (Config)#classofservice trust dot1p
Web Interface: Set classofservice Trust Mode
1. Select QoS > CoS > Basic > CoS Configuration. A screen similar to the following
displays.
Configure dot1p priority mapping.
Maps an IP DSCP value to an internal traffic class.
Sets the Class of Service Trust Mode of an Interface.
Sets the Class of Service Trust Mode of an Interface
to 802.1p.
Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
Press Enter to execute the command.
Chapter 11. CoS Queuing | 167