NETGEAR ProSafe GSM5212P Software Administration Manual page 350

Note: If there is no DHCP L3 relay between client PC and DHCP server,
there must be an active route whose subnet is the same as the
DHCP dynamic pool's subnet.
Web Interface: Configure a DHCP Server in Dynamic Mode
1. Create VLAN 200.
a. Select Switching > VLAN > Basic > VLAN Configuration. A screen similar to the
following displays.
b. Under VLAN Configuration, in the VLAN ID field, enter 200.
c. Click Add.
2. Add port 1/0/1 to VLAN 200.
a. Select Switching > VLAN >Advanced > VLAN Membership. A screen similar to the
following displays.
b. In the VLAN ID field, select 200.
c. Click Unit 1. The ports display.
350 | Chapter 22. DHCP Server
ProSafe Managed Switch