NETGEAR ProSafe GSM5212P Software Administration Manual page 363

ProSafe Managed Switch
Note: In this case, you have to configure the command
ipv6 nd other-config-flag on the interface, otherwise, the
host cannot update the DNS with it.
(Netgear Switch) (Config)#interface 2/0/21
(Netgear Switch) (Interface 2/0/21)#routing
(Netgear Switch) (Interface 2/0/21)#ipv6 address 2003:1000::1/64
(Netgear Switch) (Interface 2/0/21)#ipv6 enable
(Netgear Switch) (Interface 2/0/21)#ipv6 nd other-config-flag
(Netgear Switch) (Interface 2/0/21)#ipv6 dhcp server ipv6_server
(Netgear Switch) (Interface 2/0/21)#exit
Web Interface: Configure Stateless DHCPv6 Server
1. Enable ipv6 routing.
a. Select Routing > IPv6 > Basic > Global Configuration. A screen similar to the
following displays:
b. For IPv6 Unicast Routing, select the Enable radio button.
c. Click Apply.
2. Enable ipv6 routing on the interface 2/0/21.
a. Select Routing > IPv6 > Advanced > Interface Configuration. A screen similar to
the following displays:
b. Under IPv6 Interface Configuration, scroll down and select the Interface 2/0/21
check box. Now 2/0/21 appears in the Interface field at the top.
c. In the IPv6 Mode field, select Enable.
d. In the Routing Mode field, select Enable.
e. In the Adv Other Config Flag field, select Enable.
Chapter 23. DHCPv6 Server | 363