ProSafe Managed Switch
Web Interface: Configure a Protected Port to Isolate Ports on
the Switch
1.
Create a DHCP pool:
Note:
This example assumes that the DHCP service is enabled. For
information about how to enable the DHCP service, see the Web
interface procedure in
on page 349.
a. Select System > Services > DHCP Server > DHCP Server Configuration. A screen
similar to the following displays.
b. Under DHCP Pool Configuration, enter the following information:
•
In the Pool Name field, select Create.
•
In the Pool Name field, enter pool-a.
•
In the Type of Binding field, select Dynamic.
Configure a DHCP Server in Dynamic Mode
Chapter 15. Security Management
| 247