ProSafe Managed Switch
CLI: Configure the Maximum Rate of DHCP Messages
1.
Control the maximum rate of DHCP messages.
(Netgear Switch) (Interface 1/0/2)# ip dhcp snooping limit rate 5
2.
View the rate configured.
(GSM7328S) #show ip dhcp snooping interfaces 1/0/2
Interface
Trust State
----------
-------------
1/0/2
Web Interface: Configure the Maximum Rate of DHCP
Messages
1.
Select Security > Control > DHCP Snooping > Interface Configuration. A screen
similar to the following displays:
2.
Select the interface, fill in the Rate Limit (pps) field, and then click Apply.
The screen shows the new rate limit for the interface.
Rate Limit
(pps)
-------------
No
5
Burst Interval
(seconds)
---------------
1
Chapter 15. Security Management
| 281