Example #1: Show Classofservice Trust; Example #2: Set Classofservice Trust Mode - NETGEAR ProSafe FSM7328S Administration Manual
Managed switch
Hide thumbs
Also See for ProSafe FSM7328S:
- User manual (402 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
NETGEAR 7000 Series Managed Switch Administration Guide
Example #1: show classofservice trust
(Netgear Switch) #show classofservice trust ?
<cr>
(Netgear Switch) #show classofservice trust
Class of Service Trust Mode: Dot1P
Example #2: set classofservice trust mode
(Netgear Switch) (Config)#classofservice ?
dot1p-mapping
ip-dscp-mapping
trust
(Netgear Switch) (Config)#classofservice trust ?
dot1p
ip-dscp
(Netgear Switch) (Config)#classofservice trust dot1p ?
<cr>
(Netgear Switch) (Config)#classofservice trust dot1p
8-4
Press Enter to execute the command.
Configure dot1p priority mapping.
Maps an IP DSCP value to an internal traffic class.
Sets the Class of Service Trust Mode of an Interface.
Sets the Class of Service Trust Mode of an Interface
to 802.1p.
Sets the Class of Service Trust Mode of an Interface
to IP DSCP.
Press Enter to execute the command.
v1.0, March 2006
Class of Service (CoS) Queuing
Advertisement
Table of Contents
