Default Hsrp Configuration; Hsrp Configuration Guidelines - Cisco Catalyst 3750 Software Configuration Manual

Configuring HSRP

Default HSRP Configuration

Table 29-1
Table 29-1 Default HSRP Configuration
Feature
HSRP groups
Standby group number
Standby MAC address
Standby priority
Standby delay
Standby track interface priority
Standby hello time
Standby holdtime

HSRP Configuration Guidelines

Follow these guidelines when configuring HSRP:
•
•
•
Catalyst 3750 Metro Switch Software Configuration Guide
29-4
shows the default HSRP configuration.
HSRP can be configured on a maximum of 32 VLAN or routing interfaces.
In the following procedures, the specified interface must be one of these Layer 3 interfaces:
– Routed port: a physical port configured as a Layer 3 port by entering the no switchport
interface configuration command.
– SVI: a VLAN interface created by using the interface vlan vlan_id global configuration
command and by default a Layer 3 interface.
– Etherchannel port channel in Layer 3 mode: a port-channel logical interface created by using
the interface port-channel port-channel-number global configuration command and binding
the Ethernet interface into the channel group. For more information, see the
Layer 3 EtherChannels" section on page
All Layer 3 interfaces must have IP addresses assigned to them. See the
Interfaces" section on page
Default Setting
None configured
0
System assigned as: 0000.0c07.acXX, where XX is the HSRP
group number
100
0 (no delay)
10
3 seconds
10 seconds
27-12.
9-18.
Chapter 29 Configuring HSRP
"Configuring
"Configuring Layer 3
78-15870-01