Ipv6 Unicast-Routing - Cisco Sx350 Cli Manual

IPv6 Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
User Guidelines
If the next IPv6 address is a global IPv6 address, it should belong to a static on-link
prefix. When an on-link prefix is removed or is changed to non on-link prefix, the
static routes with next hop belonging to the prefix are removed from the
configuration.
Examples
Example 1. The following example defines a static route with a global next hop:
switchxxxxxx(config)#
Example 2. The following example defines a static route with a link-local next hop:
switchxxxxxx(config)#
FE80::260:3EFF:FE11:6770%vlan1 12

28.28 ipv6 unicast-routing

Use the ipv6 unicast-routing command in Global Configuration mode to enable the
forwarding of IPv6 Unicast datagrams.
To disable the forwarding of IPv6 Unicast datagrams, use the no form of this
command.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Parameters
N/A.
Default Configuration
IPv6 Unicast routing is disabled.
Command Mode
Global Configuration mode
ipv6 route 2001::/64 5::5 10
ipv6 route 2001:DB8:2222::/48
28
586