Network and Security Manager Administration Guide
162
Figure 36: Adding the Second Member to a J Series Cluster
Click Finish.
8.
If you expand the cluster icon in the Device Manager, you will see the new cluster members,
as shown in Figure 36 on page 172.
Figure 37: Cluster Member Icons
Activating the Cluster Members
When the cluster has been properly installed, activate the cluster as follows:
On each cluster member device, configure logon credentials for the NSM
1.
administrator,
In NSM, activate each cluster member as follows:
2.
Expand J-Cluster in the Device Manager to show the icons for each of the cluster
a.
members.
Right-click the cluster member icon (J-1)in the Device Manager and select
b.
Activate Device from the list.
Click the Device deployed, but IP is not reachable radio button.
c.
Click Next to display the Specify connections setting dialog box.
d.
Make a note the Unique External ID. The device administrator will need this ID
e.
to connect with NSM from the member device.
Copyright © 2010, Juniper Networks, Inc.