Setting Device Log Action Criteria - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
788
NSM uses this information when exporting qualified log entries to CSV. This setting
defines the CSV settings for the management system. To export logs to CSV, you must
select "CSV Enable" from the Actions tab in the Device Log Action Criteria node.
Exporting to XML
For exporting to XML, configure the directory and filename to which you want to send
qualified logs in XML format. NSM uses this information when exporting qualified log
entries to XML; each log becomes an XML record, which you can open in most Web
browsers.
This setting defines the XML settings for the management system. To actually export
logs to XML, you must select "XML Enable" from the Actions tab in the Device Log Action
Criteria node.
Exporting to E-mail
For exporting to e-mail, configure the following e-mail and SMTP settings:
SMTP Enable—Enables the SMTP server to send e-mail.
Default 'From' Email Address—Some servers require a valid "from" e-mail address to
relay mail.
Default 'To' Email Addresses—The e-mail address that receives e-mail alarms. You
can specify multiple "to" e-mail addresses.
NSM uses the preceding information when exporting qualified log entries to e-mail. These
settings define the e-mail and SMTP settings for the management system.
NOTE: After editing your e-mail settings, you must restart the Device Server for your
changes to take effect

Setting Device Log Action Criteria

A Device Log Action Criteria instance defines the criteria for a qualified log; each instance
contains two criteria settings (category and severity), and multiple action settings for
logs that meet the criteria settings. For example, to only export critical severity attack
logs to XML, you create a device log action criteria instance that specifies the log category
as predefined, the severity as critical, and the action as XML. For each log entry that
matches the criteria, NSM exports the log as XML, using the default XML settings
configured in the Actions tab.
To add a new Device Log Action Criteria instance, use the Add button, then configure
the following settings.
Selecting Category
In the Category list, select a category of log entry for the criteria. Some categories contain
subcategories; however, to set an action based on a subcategory, you must first select
a category.
For details on each category and subcategory, see "Log Entries" on page 861.
Copyright © 2010, Juniper Networks, Inc.