Disabling 802.1X On Enforcement Point Ports In The Uac Manager - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Disabling 802.1X on Enforcement Point Ports in the UAC Manager

Resolving Configuration Conflicts Between Devices and 802.1X Ports in the UAC
Manager
Copyright © 2010, Juniper Networks, Inc.
To disable 802.1X on ports on Enforcement Points (EP):
Select the Delete button (-) below the Port Details tab.
1.
Select one or more ports on the EP on which to disable 802.1X.
2.
Select the check box to run an Update Device task, which pushes configuration
3.
changes on the EP. The configuration status of the EPs changes to Managed, InSync.
Ports on which 802.1X is disabled are removed from the EP.
Select the check box to run a Summarize Delta Config task that ensures the
4.
association between the EP and the ports in the application database. The
configuration status of these devices become Managed, NSM Changed.
Select OK.
5.
The Resolve Configuration Conflict option allows you to detect any inconsistency between
the device configuration and 802.1X interfaces data administered in NSM by the UAC
Manager. To resolve a conflict:
Right-click on a selected Infranet Controller.
1.
Select Resolve Configuration Conflict. A dialog box displays details of port
2.
associations.
Select an action for NSM to execute:
3.
Update the 802.1X port configuration in the Enforcement Point
Update NSM
Select the check box to run an Update Device task, which pushes configuration
4.
changes on the EP.
Select the check box to run a Summarize Delta Config task that ensures the
5.
association between the EP and the ports in the application database.
Select OK.
6.
Chapter 16: Unified Access Control Manager
645