Figure 61: Applying A Configuration Group; Figure 62: Configuration Group Applied; Excluding A Configuration Group - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Excluding a Configuration Group

Copyright © 2010, Juniper Networks, Inc.

Figure 61: Applying a Configuration Group

Select the desired configuration groups from the Available Config Groups list, and
3.
then click Add. The Available Config Groups list includes all configuration groups
created in the device object.
The configuration group and icon move to the Applied Config Groups list.
Click OK to apply the configuration group.
4.
NOTE: The first configuration group in the list has the highest priority. This convention
is the reverse of the ordering for templates, where the last template in the list has the
highest priority.

Figure 62: Configuration Group Applied

Configuration groups applied at a higher level in the configuration can be explicitly
excluded at lower levels. To exclude a configuration group from a branch of the
configuration, follow these steps:
Right-click on the branch and select Apply/Exclude Config Groups from the list.
1.
Chapter 5: Configuring Devices
225