Configuring A Vpn Filter; Modifying A Vpn Filter - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Configuring a VPN FIlter

Modifying a VPN FIlter

Copyright © 2010, Juniper Networks, Inc.
You can configure a VPN filter to control the information that is provided in the VPN
Monitor. You can view VPN information related to the type, status, or the specific security
device or virtual system associated with the VPN tunnel that you want to view.
To create a VPN filter:
Select Report Manager > VPN Monitor
1.
From the Option menu, select VPN Filter.
2.
The VPN Filter dialog box is displayed.
Click the add icon.
3.
The New VPN Filter dialog box is displayed.
In the Type area, select RAS, Site to Site, or Default to view both types of VPN.
4.
In the Device/Vsys area, select the type of device or virtual system associated with
5.
the VPN tunnel. Select Include all selected devices.
TIP: In the Selected Devices/Vsys area, by default, all devices or virtual systems are
included in the filter. To improve system performance, you can remove devices or virtual
systems by selecting them and clicking Remove. Next, select Exclude all selected
devices.
Click OK to save the filter.
7.
The new VPN filter is updated in the Filter Table.
Click Apply to activate the selected filter. The filter results are shown in the VPN
8.
Monitor view.
To modify a VPN filter:
Select Report Manager > VPN Monitor
1.
From the Option menu, select VPN Filter.
2.
The VPN Filter dialog box is displayed.
Select the edit icon.
3.
The View VPN Filter dialog box is displayed.
Change the existing field values and click OK.
4.
The modified field values are updated in the Filter Table.
Chapter 17: Realtime Monitoring
681