Table 72: Vsd/Rto Summary; Table 73: Vsd Counter Details - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide
684

Table 72: VSD/RTO Summary

Item
Cluster
VSD(RTO)
No of Devices
Init Hold Time (sec)
Heartbeat Interval (ms)
Heartbeat Lost Threshold (ms)
Master
Primary Backup
Viewing VSD Counter Details
Click the Counters tab to view specific information about your VSD counters. Table 73
on page 684 describes the information that is available from the VSD counters view:

Table 73: VSD Counter Details

Item
Device
Number of Units
State Change Counter
Init Counter
Master
Primary BackUp
BackUp
Ineligible
InOperable
Master Conflict
Description
The name of the cluster associated with this VSD.
The name of this VSD (or RTO).
The total number of security devices that are associated with
this VSD.
The initial hold time state (in seconds) of the VSD.
The time interval (in milliseconds) between each heartbeat.
Threshold level required to change over to the backup security
device.
The master system.
The primary backup system.
Description
The devices that are associated with the VSD or RTO.
The number of units associated with the VSD or RTO.
The number of times a device changes operational states.
The transient state of a VSD or RTO group member while it was in
the process of joining the VSD or RTO group.
The number of master devices.
The number of primary backup devices.
The total number of backup devices.
An administrator purposefully assigned a device so that it cannot
participate in selecting a new master device.
A VSD or RTO group device has an internal problem.
The number of conflicts that occurred on the master device.
Copyright © 2010, Juniper Networks, Inc.