Table of Contents
Advertisement
Network and Security Manager Administration Guide
204
a.
Add a NetScreen-208 security device to the management system, and model
the configuration. Be sure to configure the device as running ScreenOS 5.0.
b.
In the navigation tree, select Device Manager > Devices. Double-click the
NetScreen-208 device icon to open the device editor.
c.
Select Info > Templates in the device navigation tree. Click the Edit icon in the
Templates screen. The Edit Templates dialog box appears.
d.
Select the DoS template.
e.
Click OK in the Edit Templates dialog box.
Verify that the DoS template values have been applied to the device:
3.
a.
Select Network > Zone in the device navigation tree. Double-click the untrust
zone. The untrust-Predefined Zone dialog box appears.
b.
Select Screen > Denial of Service Defense and review the values applied by
the template, as shown in Figure 48 on page 204.
Figure 48: View Denial of Service Defense Values from DoS Template
Create a second template that sets a different value for a SCREEN option than was
4.
set in the DoS template:
a.
In the navigation tree, select Device Manager > Devices Templates, click the
Add icon, and then select ScreenOS/IDP Template. The New Device Template
dialog box appears.
b.
In the Info screen, enter DoS2 in the Name field.
c.
In the template navigation tree, select Network > Zone. The Zone configuration
screen appears.
d.
Click the Add icon in the Zone configuration screen and select Pre-Defined
Security Zone—trust|untrust|dmz|global. The Predefined Zone dialog box
appears.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
