Understanding Updating Errors - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Understanding Updating Errors

258
When an update fails for any reason, Job Manager displays error codes and error messages
that can help you identify and locate the problem. Typical errors include:
The modeled configuration contained invalid values that the device could not process.
During the update process, the connection between the managed device and the Device
Server was lost.
The modeled configuration caused the managed device to lose its connection to NSM.
For these update errors, the Job Information dialog box displays the Job Status as "Failed."
You can also check the Connection Status and Configuration Status columns for the
device in the Realtime Monitor to determine whether the device is running.
After a device is updated, you can run a delta configuration summary to determine any
remaining differences between the modeled configuration and the running configuration;
the output of this summary appears in the Job Manager information window. For
successful updates, no discrepancies are found or displayed. For failed updates, the
output area lists remaining discrepancies.
For example, a failed update job is shown in Figure 69 on page 259.
Copyright © 2010, Juniper Networks, Inc.