Table 74: Rto Counters Details; Table 75: Idp Cluster Monitor; Viewing Rto Counter Details; Monitoring Idp Clusters - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Monitoring IDP Clusters

Copyright © 2010, Juniper Networks, Inc.
Table 73: VSD Counter Details (continued)
Item
Primary Backup Conflict
Tx Heartbeat
Rx Heartbeat

Viewing RTO Counter Details

Click the Counters tab to view specific information about your RTO counters. Table 74
on page 685 describes the information that is available from the RTO counters view:

Table 74: RTO Counters Details

Item
Device
Member ID
Status
Direction
Lost Heartbeat
Counter to Active
Counter to Set
Counter to Lost Peer
Counter to Group Detach
If you have implemented IDP clusters for the purpose of redundancy, you can use the
IDP Cluster Monitor to get an at-a-glance status of your IDP sensors that are in clusters.
Table 75 on page 685 describes all of the information available from the IDP Cluster
Monitor:

Table 75: IDP Cluster Monitor

Item Description
Name Name of the cluster.
Status Status of the cluster (OK, Warning, or Fail).
Description
The number of conflicts that occurred on the primary backup device.
The number of transmitted heartbeats on the devices.
The number of received heartbeats on the devices.
Description
The devices that are associated with the RTO.
The member identification associated with this RTO.
The current status of the RTO: Active or Down.
The direction of the RTO: In or Out.
The number of heartbeats not received from the RTOs peers.
The number of times that the RTO was placed to Active.
The number of times that the RTO was placed to Set.
The number of times that the RTO was placed to Lost Peer.
The number of times that the RTO was placed to Group Detach.
Chapter 17: Realtime Monitoring
685