Table of Contents
Advertisement
Network and Security Manager Administration Guide
580
d.
For VPN Type, select Policy-Based.
e.
Click OK to save the VPN and return to VPN Manager.
f.
In VPN Manager, select the Tokyo-Paris Policy-Based VPN. The VPN appears
in the main display area.
Configure the policy-based members:
6.
a.
Select the Protected Resources link to display the Protected Resources list.
b.
Select the Paris Protected Resources and the Tokyo Protected Resources.
c.
Click OK to return to the main display area.
Configure the VPN topology:
7.
a.
Select the Topology link to display the Topology dialog box.
b.
Click the Add icon to display the Topology configuration dialog box. Configure
the following:
For Hub and Supernet, leave the default of none.
Enable Mesh Main(s).
In the Mains window, select the Paris and Tokyo security devices.
c.
Click OK to return to the Topology dialog box, then click OK to return to the main
display area.
Configure the termination points of the VPN:
8.
a.
Click the Termination Points link. The Termination Points dialog box appears.
b.
Confirm that both Paris and Tokyo devices use a Termination Interface of
ethernet3.
c.
Click OK to return to the main display area.
Configure the VPN gateway:
9.
Click the Gateway Parameters link. The Properties tab appears. Leave all defaults
and click the Security tab.
In the Security tab, configure the PKI Information and Phase 1 Proposals as shown
in Figure 89 on page 581.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Related Manuals for Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
Related Products for Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - CONFIGURING INTRUSION DETECTION AND PREVENTION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INTRUSION DETECTION PREVENTION DEVICES GUIDE REV 01
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - API GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.3 - M-SERIES AND MX-SERIES DEVICES GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.2 - ADMINISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING J SERIES SERVICES ROUTERS AND SRX SERIES SERVICES GATEWAYS GUIDE REV
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - ADMININISTRATION GUIDE REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - NSMXPRESS SERIES II REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - REV1
- Juniper NETWORK AND SECURITY MANAGER 2010.4 - M-SERIES AND MX-SERIES DEVICES GUIDE REV 1
- Juniper NETWORK AND SECURITY MANAGER 2010.2
- Juniper MEDIA FLOW MANAGER 2.0.2 - ADMINISTRATOR S GUIDE AND CLI
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 - CATEGORY OFFENSE INVESTIGATION GUIDE REV 1
- Juniper SECURITY THREAT RESPONSE MANAGER 2008.2 R2 - LOG MANAGEMENT ADMINISTRATION GUIDE REV 1
- Juniper MEDIA FLOW CONTROLLER 2.0.5
- Juniper 200 Series