Table 41: Source Nat Configuration Options - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Table 41: Source NAT Configuration Options

Tab Field
General Name
Routing Ri Name
Instance
Address IP
/
Address Ipaddr
/
Port Translation Low High
Host Address Ipaddr
Base
Overflow Pool
412
The devices are listed only if you have previously added these devices to NSM. To
add a device, use the
If a device is not selected, you cannot configure the
fields.
If the proxy ARP functionality is required, select the IP address of the interface, which
4.
accepts the ARP requests, from the
select ( + ) to configure a new value. The
the logical interface on which to configure proxy ARP and its details. For more
information, see "Configuring Proxy ARP" on page 413.
Select ( ) next to
+ Junossource-nat
5.
dialog box appears.
You will see a list of values to select from the drop-down list if you have previously
configured address pools.
Table 41 on page 412 lists the fields that are available and the action you need to
perform on each fields.
Function
Descriptive name for the pool.
Specify the routing instance to which the
pool is bound.
Specify address prefixes, addresses, or a
range of addresses or address prefixes.
Specify whether port translation must be
performed or not.
Specify the base address of the original
source IP address range. This is used for
IP shifting.
Specify a source pool to use when the
current address pool is exhausted. The
pool can be a user-defined pool or the IP
address of an interface.
.
Device Manager
drop-down list. If no values are listed,
Proxy ARP
New Interface
to configure the address pool. The
Action
Type a name for the pool.
Select the routing instance name. The values
are listed only if you have added them
previously. To add a new routing instance to
a device, select
Instance Objects
Click the Add or Delete icons to configure or
remove address entries.
By default, port translation is enabled. Enter
a port range.
Select the
port translation.
Enter the IP address.
—No overflow pool.
None
Pool-name
Interface
interface.
Proxy-ARP and Junossource-nat
dialog box appears. Specify
New Pool
>
Object Manager Routing
.
check box to disable
No Translation
—Select a user-defined pool.
—Enter the IP address of the
Copyright © 2010, Juniper Networks, Inc.
)