Customizing Columns; Using Column Settings; Hide, Unhide, And Move Columns - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Customizing Columns

762
To filter on a minimum port number only, select From and enter a value. When
applied, this filter displays log entries for events that used a port greater than or
equal to the specified minimum port number.
To filter on a maximum port number only, select To and enter a value. When
applied, this filter displays log entries for events that used a port less than or equal
to the specified maximum port number.
To filter on a range of port numbers, select From and To, then enter the minimum
and maximum values for the range. When applied, this filter displays log entries
for events that used ports within the specified range.
Click OK to apply the filter.
3.
You can configure the Log Viewer to display specific columns.

Using Column Settings

The Log Viewer includes 46 columns of log entry information; however, each predefined
view includes only a small subset of available columns. To view information in the other
available columns, or to change the column display order, you can adjust the column
settings for the view.
The more columns you configure to appear in the Log Viewer, the more information you
can see at one time—and the more you must scroll from side to side to view all columns;
setting fewer columns means less viewable information, but also less scrolling. Typically,
you use fewer columns when you already have enough detail about the event or you are
only interested in specific event data.
Use column selection in combination with filters to create a customized view of your log
entries.

Hide, Unhide, and Move Columns

You hide, unhide, or move columns to display specific information using one of the
following methods:
When managing columns using the Column Settings dialog box:
To display hidden columns, select the columns and click Show.
To hide columns, select the columns and click Hide.
To reorder the column display sequence, select a column and click Move Up or Move
Down.
When managing columns in the main display area:
To hide a column, right-click the column header and select Hide Column. To unhide
a hidden column, you must use the Column Settings dialog box.
To reorder the column display sequence, drag a column to a new location.
Copyright © 2010, Juniper Networks, Inc.