Figure 60: Adding A Configuration Group; Editing A Configuration Group - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
Click the Add icon again and name the second entry with a wildcard character
f.
<*>. Include the angle brackets, because they are required by the Junos syntax.
In the Speed field, set the speed to 1g and click OK.
g.
The configuration group icon appears next to the two interface entries in the
group, and next to each element in the tree above the interface entries. See
Figure 60 on page 223. Mouse over the icons to see a summary of what has been
set and where the information came from.

Figure 60: Adding a Configuration Group

Click OK to save the configuration group. The new configuration group appears in
6.
the Config Groups List.
NOTE: After saving a configuration group, you cannot change its name.

Editing a Configuration Group

You can edit configuration groups before or after applying them. If you edit the group
after applying it, then the new edits take effect immediately in the device object.
Chapter 5: Configuring Devices
223