Network and Security Manager Administration Guide
Example: Adding and Importing a Cluster
158
You need push the configuration to only the primary cluster member, because
software on the cluster ensures that both cluster members are synchronized.
This example adds to NSM a Secure Access cluster that already exists on the network
and imports the configuration into NSM. The cluster in this example has two members:
SA-1 and SA-2. Adding and importing a cluster consists of three major steps:
Adding the Cluster on page 158
Adding the Cluster Members on page 159
Importing the Cluster configuration on page 160
Adding the Cluster
Add a new cluster to NSM as follows:
Select Device Manager > Devices, and then click the Add icon and select Cluster
1.
from the list.
The Add Cluster wizard starts.
Enter the cluster-level information into the New Cluster dialog box as shown in Figure
2.
33 on page 158.
Figure 33: Adding a Secure Access Cluster
Click OK.
3.
The new cluster appears in the Device Manager.
Copyright © 2010, Juniper Networks, Inc.