Table 78: Server Information; Configuring Servers; Configuring Device Servers - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Configuring Servers

688
and Security Manager Installation Guide for more information about the GUI Server and
Device Server.
The Server Manager contains the following:
Servers
Server Monitor (Machine-wide info)
Schema Information
Use Servers to add, configure and view key information about the GUI Server and Device
Server:
Table 78 on page 688 lists and describes Device Server and GUI Server information that
you can view from Servers .

Table 78: Server Information

Item
Name
Server Type
IP Address
Device Server Manager Port
IDP Device Server Manager
Port
DMI Device Server Manager
Port
IP Address of Secondary
Server

Configuring Device Servers

You can also add and configure a Device Server. You might need to configure a Device
Server when installing the GUI Server and Device Server on separate servers, or when
installing the management system with High Availability (HA) enabled.
You can configure the following parameters on a Device Server:
Name—Name of the Device Server.
IP Address—IP address of the Device Server.
Description
Name of the GUI Server or Device Server.
Whether the current server is Device Server, Device Server Cluster,
GUI Server, or GUI Server Cluster.
IP address of the server.
The port open on the Device Server for security devices running
ScreenOS 5.0 and later. (Read Only)
The port open on the IDP Device Server for security devices.
The port open on the DMI Device Server for security devices.
IP address of the secondary server.
Copyright © 2010, Juniper Networks, Inc.