Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual page 886

Network and Security Manager Administration Guide
Log ID
Log Investigator
Log Viewer
Loopback Interface
M
Main Display Area
Management System
Mapped IP Address
MCC
MD5
Media Gateway
Control Protocol
(MGCP)
Member AS
Menu Bar
Metric
MNC
836
A log ID is a unique ID for the log entry, derived from the combination of the date and log
number.
The Log Investigator is a module of the NSM User Interface. The Log Investigator contains
tools for analyzing your log entries in depth. Use the Log Investigator to manipulate and change
constraints on log information, correlate log entries visually and rapidly, and filter log entries
while maintaining the broader picture.
The Log Viewer is a module of the NSM User Interface. The Log Viewer displays log entries
that your security devices generate based on criteria that you defined in your security policies,
on the Device Server, and in the device configuration. Logs appear in table format; each row
contains a single log, and each column defines specific information for a log.
A logical interface that emulates a physical interface on the security device, but is always in
the up state as long as the device is up. You must assign an IP address to a loopback interface
and bind it to a security zone.
The main display area displays the content for the currently selected module or module
contents.
The management system includes the GUI Server and Device Server. You can deploy the GUI
Server and Device Server on separate servers; however, the combination of the two servers is
known as the management system.
A MIP is a direct one-to-one mapping of traffic destined for one IP address to another IP
address.
Mobile Country Code.
Message Digest (version) 5 is an algorithm that produces a 128-bit message digest (or hash)
from a message of arbitrary length. The resulting hash is used to verify authenticity.
MGCP is a text-based, application layer protocol that can be used for call setup and call control.
The protocol is based on a master/slave call control architecture: the media gateway controller
(call agent) maintains call control intelligence, and media gateways carry out the instructions
from the call agent.
The name of the autonomous system being included in a BGP confederation.
The menu bar is the upper section of the NSM UI. The menu bar contains accessible commands.
A value associated with a route that the virtual router uses to select the active route when
there are multiple routes to the same destination network with the same preference value.
The metric value for connected routes is always 0. The default metric value for static routes
is 1, but you can specify a different value when defining a static route.
Mobile Network Code.
Copyright © 2010, Juniper Networks, Inc.