Figure 63: Excluding A Configuration Group; Editing A Device Object That Uses Configuration Groups - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Network and Security Manager Administration Guide

Editing a Device Object That Uses Configuration Groups

226
The Apply/Exclude Config Groups dialog box appears. All configuration groups
applied at higher levels in the configuration appear in the Inherited Config Groups
list. Figure 63 on page 226 shows an example.

Figure 63: Excluding a Configuration Group

In the Inherited Config Groups list, select the configuration groups you want to exclude,
2.
and then click Add,
The selected configuration group names move to the Excluded list.
Click OK to exclude those groups from that part of the configuration.
3.
After you apply the configuration group, tooltip icons identify where configuration groups
have affected the configuration. You can mouse over these items to display information
about them.
When you edit an entity that was derived from a configuration group, the new value
overrides the value derived from the configuration group. The tooltip icon changes so
you can easily identify which entries have been overridden,
To revert to the configuration group value for a specific field, right-click on the field, and
select Revert to template/default value.
NOTE: Nonwildcard list entries derived from configuration groups cannot be deleted
in the device object.
Copyright © 2010, Juniper Networks, Inc.