Figure 28: Combined Port Mode Bindings; Trust-Untrust-Dmz Port Mode - Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual

Copyright © 2010, Juniper Networks, Inc.
NOTE: For the NetScreen-5XT, the Combined port mode is supported only on the
NetScreen-5XT Elite (unrestricted users) platform.
See Figure 28 on page 107 for port, interface, and zone bindings.

Figure 28: Combined Port Mode Bindings

This mode provides the following bindings:
Binds the Untrusted Ethernet port to the ethernet4 interface, which is bound to the
Untrust zone.
Binds Ethernet port 4 to the ethernet3 interface, which is bound as a backup interface
to the Untrust zone (the ethernet4 interface is the primary interface to the Untrust
security zone).
Binds the Ethernet ports 3 and 2 to the ethernet2 interface, which is bound to the Home
zone.
Binds Ethernet port 1 to the ethernet1 interface, which is bound to the Work zone.
NOTE: The serial interface is not available in Combined port mode.

Trust-Untrust-DMZ Port Mode

Trust/Untrust/DMZ mode binds interfaces to the Untrust, Trust and DMZ security zones,
enabling you to segregate Web, e-mail, or other application servers from the internal
network.
NOTE: The Trust/Untrust/DMZ port mode is supported only on the NetScreen-5GT
Extended platform.
See Figure 29 on page 108 for port, interface, and zone bindings.
Chapter 4: Adding Devices
107