Table of Contents
Advertisement
Installing the Configlet
Copyright © 2010, Juniper Networks, Inc.
indicating that the device has connected but the management system has not yet
installed the modeled device configuration.
The onsite administrator performs RD in two stages:
Preparing the security device
Installing the configlet
The following sections detail each stage. For detailed, step-by-step instructions on
installing the configlet, see the Rapid Deployment Getting Started Guide.
Preparing the Device
Before you install the configlet, you must prepare the security device:
Connect the device to your network. For details on connecting the device, see the
1.
user's guide that came with your security device.
Connect a standalone computer, such as a laptop, to the device's eth1 port.
2.
To connect directly to the device, use a crossover cable.
To connect to the device over a hub or switch, use a straight-through cable.
If your device has auto-sensing ports, you can use any type of Ethernet cable to
connect to the device.
Change the IP address of the standalone computer to
3.
gateway to
. To change an IP address, see your computer's operating
192.168.1.1
system documentation.
Ensure that the device is using the factory default settings.
4.
RD works with the factory default settings of all security devices running ScreenOS
5.x or a later release. If the device does not use the factory default settings, you
cannot use RD (the WebUI cannot load the configlet).
To restore the factory defaults on the firewall device, see the user's guide that
came with your security device.
Ensure that the Status LED on firewall device displays green.
5.
Installing the Configlet
NOTE: During the configlet installation process, you cannot edit the device configuration.
To install the configlet:
Save the configlet on the standalone computer that you connected to the security
1.
device.
In a Web browser, enter the IP address of the trust interface on the security device
2.
as
192.168.1.1
. The Rapid Deployment Wizard appears.
Chapter 4: Adding Devices
and the default
192.168.1.2
143
Advertisement
Table of Contents
