Juniper NETWORK AND SECURITY MANAGER 2010.3 - ADMINISTRATION GUIDE REV1 Administration Manual page 463

Copyright © 2010, Juniper Networks, Inc.
Configuring Proxy ARP
To configure proxy ARP:
In the dialog box, enter the name of the interface. To navigate to this
New Interface
1.
dialog box, see steps 1 to 4 of "Adding a Source NAT Object" on page 411.
Specify the hosts (range of IP addresses) whose ARP requests this device must
2.
accept, as follows:
Click and select (+) to configure the start of the address range in the
Address
dialog box.
Click and configure the end of the address range.
To
Click .
OK
Click . Proxy ARP is now configured.
3. OK
Editing a Source NAT Object
To edit a source NAT object:
Select
1. Object Manager
box appears.
Select a source NAT object to edit.
2.
Select the Edit icon at the top of the screen. The
3.
Select the device to edit.
4.
Select the Edit icon. The
5.
Edit the values of the source NAT object.
6.
Click .
7. OK
Deleting a Source NAT Object
To delete a source NAT object:
Select
1. Object Manager
box appears.
Select a source NAT object to delete.
2.
Select the Delete icon (
3.
The
Delete JunosSource NAT Source NAT-object name
Click Next .
4.
If you have referenced this object, then all referenced areas are displayed as links in
this dialog box. Click on a link to navigate to the area where this object is referenced.
You can proceed with or cancel the deletion. If the deletion is successful, the following
message appears in the dialog box:
Click .
5. Finish
> >
Junos NAT Objects Source NAT
JunosSource NAT
dialog box appears.
Junos Source NAT
> >
Junos NAT Objects Source NAT
- ) at the top of the screen.
Deleted Source NAT-object name
Chapter 8: Configuring Objects
New
. The dialog
Source NAT
dialog box appears.
. The dialog
Source NAT
dialog box appears.
.
413