Network Mode Selection - Enable Dhcp If Box Checked - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Network Mode Selection - Enable DHCP if Box Checked

JUPITER L-S and LCD Series Control Panel Instruction Manual
Net-1 IP Settings
Figure 34. Net-1 IP Settings
1. Enter a unique value in the Ethernet IP field. This IP address must be
within the same network as the AccuSwitch controller.
For example, if a CM-4000 address is 192.168.253.10, then the L-S or
LCD Panels address should be changed to reside in the 192.168.253.x
network (such as "192.168.253.101").
2. Enter 255.255.255.0 in the Subnet Mask field.
3. Enter a unique value in the Gateway field. This number is similar to the
Ethernet IP, except the last set of numbers should be "1."
If the L-S or LCD Panels and the AccuSwitch controller are on separate
networks, the gateway connecting them must be specified.
Net-2 IP Settings:
Not used to configure the panel.
You must have a DHCP server to use this option.
Figure 35. Enable DHCP Settings
Follow these steps if you wish to use DHCP:
1. Select or place a check in, the
DHCP mode.
2. Select or place a check in, the
DHCP mode.
3. Enter the amount of time, in seconds, for the panel to try to connect to
the DHCP server before the connection will time out in the DHCP Mode
time-out (sec) field.
check box to turn on
Net-1: Set DHCP Mode
check box to turn on
Net-2: Set DHCP Mode
Serial Data Cables
73