Table of Contents
Advertisement
LCD Series Panel Operation
Introduction
Basic Panel Operations
Taking a Source to a Destination (Take)
Advise Router Option
JUPITER L-S and LCD Series Control Panel Instruction Manual165
This section assumes that the LCD panels have been properly installed and
configured for operation at your facility. Buttons are configured to control
Sources and Destinations using the Jupiter CP Input and Output sets.
Levels are determined with CP Level sets. These sets are assigned to the
panel using the MPK Devices table (see Section 4-Jupiter System Configura-
tion).
The following section will explain how to perform a Take for the various
available modes, how to use the Protect and Lock features, and how to use
the menu options.
The most basic operation of any router control panel consists of selecting a
router Destination, followed by selecting a router Source. This process con-
nects the router input (Source) signals to the router outputs (Destination).
This process is called a Take. The Take process will be described for each
available operating mode in the following sections.
When the Advise option has been set in the Jupiter Control system and an
attempt is made to switch control to a new device, the switch will not occur.
The system will instead display the following message on the control panel
in two lines:
SRC in use
by: <Destination name>
11
Section
Advertisement
Table of Contents
