Selecting A Source (Multiple Destination Mode); Adding Or Changing A Destination Soft Button Assignment - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Selecting a Source (Multiple Destination Mode)

Adding or Changing a Destination Soft Button Assignment

JUPITER L-S and LCD Series Control Panel Instruction Manual115
Once Destination(s) to be controlled are selected, the Source is switched in
basically the same was as in Single Destination mode (see Selecting a Source
(Single Destination Mode)
Direct Category Button Method
1. Press a Category (For example, "VTR") and unit number (For example,
"2") button combination.
2. Press .
Take
Page Selection Method
1. Press , then press the D4 window
Menu
2. The D1 window will display
groups of four, in green, in the D1-D4 windows.
3. Use the arrow buttons to scroll through the available Sources.
Up/Down
4. Select the desired Source by pressing its adjacent soft button.
5. To execute the switch, press
active Destination(s).
A Destination may be added to any unused location in the D1-D4 displays.
One additional page will be available when adding Destination assign-
ments. Destinations can also be changed or deleted.
Note Destinations that have been defined in the panel's CP Output set using the
Jupiter Configuration Editor cannot be changed using the panel itself. If such
an attempt is made, the panel will display the following message: "????" For
more information see Section 4-Jupiter System Configuration.
1. Press , then press the D3 window
Menu
page of Destination names will be displayed in the windows.
2. Press the soft button next to the desired button location. Use the
arrow buttons if necessary to scroll through the pages of button
locations.
3. Select the desired Destination by pressing a category (For example,
"VTR") and unit number combination. The name of the Destination,
and the category/number, will appear in the window.
4. Press . The Destination will appear in the selected location.
Take
5. To assign more Destinations, repeat
6. When finished, press
on page 111 for detailed information).
Select Source?
in white. Sources will appear in
Source?
. The Source will be switched to the
Take
Select Destination?
Step 2
and then to exit the mode.
Menu Clear
LD4 Control Panel
soft button.
soft button. A
Up/Down
through Step 4.