Section 4 - Jupiter System Configuration; Mpk Table Entries - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Jupiter System Configuration

MPK Table Entries

MPK Devices
MPK Device
Devices Type
JEP1 CPESXTND
1
JEP2 CPESXTND
2
JEP64 CPESXTND
64
JUPITER L-S and LCD Series Control Panel Instruction Manual
The following overview of L-S series panel configuration assumes that the
reader is familiar with the Jupiter Facility Control System. Please refer to
the Jupiter CM-4000 Installation and Operating manual or the Jupiter CM-4400
Installation and Operating manual for specific information.
The Jupiter MPK table is used for configuration purposes. The example
shown in Figure 26
Figure 26. MPK Devices Table
Pass
Expansion Board Port Address
word
CM1 01
75
CM1 02
CM1 64
92
:This column is used to create a name, up to eight characters in
MPK Devices
length, for each L-S panel. This name must be unique system-wide.
: Select type
Device Type
For L-S series panels, leave unchecked.
Expansion:
: A password level will only need to be entered if you wish to
Password
disable the Configuration and Setup menus on the Control panel. See the
Disabling the Configuration and Setup Menus on the Control Panel
below for more information.
Note Panels can be configured to force unlock and force un-protect any destination
regardless of what panel locked or protected it, depending on what is entered
in the Password column. See the 7.8.1 Jupiter Release notes (part #
071827511) for more information.
: Name of CM-4000 or CM-4400 that is associated with this panel. The
Board
Source of this name is the Network Description table.
applies to the system shown in
Input Sets In Panel Output Sets
KXYZINP KXYZOUT
KXYZINP KXYZOUT
KXYZINP KXYZOUT
CPESXTND from the pull-down menu.
" "
Section
Figure 23 on page
Out Panel Level Set Overide Set
KXYZLEV
KXYZLEV
KXYZLEV
section
4
53.
Sequence Set
K
59