Table of Contents
Advertisement
Section 6 — L-S Series Panel Operation
5/6/7/8 Destinations
Operation
S25/S50 Protect/Lock
Normal and Sticky Level Modes
130
With five, six, seven, or eight Destinations defined, the eight-button cluster
on the right is used to select the Destination. Breakaway switching is not
available with this configuration. An example is shown in
Figure 75. S50 Configured for 8 Destinations
Sources
1. Select the Destination button on the right you wish to control.
2. Press a Source button (light green). Selecting the Source completes the
switch to the Destination.
S25 and S50 panels cannot initiate or remove protects or locks.
If a Destination has been
button will illuminate steady amber and the Destination will not switch. If
the Destination has been
will illuminate steady red and the Destination will not switch. To continue,
the Destination must be unprotected or unlocked by the panel used to set
the protect or lock.
The S25/S50 panel can operate in a Normal or Sticky Level mode. The
Sticky level mode / level breakaways are not available when more than
four destinations are configured.
With Normal mode, after any take has been selected by pressing a Source
button, the S25 panel will automatically re-select (or turn on) all the config-
ured level buttons to the High Tally state that indicates that these levels
have been selected and will be taken to the destination when the next
source take is requested. This is known as an, "All level take." This action
will occur regardless of what had been previously unselected prior to the
last source take. Also, the
has the first selected level confirmed.
JUPITER L-S and LCD Series Control Panel Instruction Manual
protected
by another panel, the selected Source
locked
by another panel, the selected Source button
button status will move to the Source that
Source
Figure
75.
8 Destinations
S50
Advertisement
Table of Contents
