Table of Contents
Advertisement
Section 6 — L-S Series Panel Operation
Breakaways (LD4 Panel)
112
Direct Category Button Method
This is the fastest method to take a Source to Destination on this panel.
1. Confirm the desired active Destination is shown in yellow in the
Destination window.
2. Press a Category (For example, "VTR") and unit number (For example,
"2") button combination. If the entry is valid, the defined category/
number will be displayed in the D16 window, in Blue.
The mnemonic for the Source will be shown in the Status window, top
row, and also appears in the various level displays (the D1-D4 win-
dows).
3. Press
. All selected levels will switch to the new Source. The
Take
mnemonic of the new Source will be displayed in the Status window, in
green. The level displays will show the Source name, in green, for each
of the first 4 levels defined in the CP Level set assigned to the panel.
Page Selection Method
1. Confirm the desired active Destination is shown in yellow in the
Destination window
2. Press
and push the
Menu
The D1 window will display
groups of four, in green, in the D1-D4 windows.
3. Use the
arrow buttons to scroll through the available Sources.
Up/Down
Note
The same as Destination selection, you can restrict the Sources displayed in
the windows by pressing a Category button at this time (see Category Subset
Method
on page
4. Select the desired Source by pressing its adjacent soft button.
5. To execute the switch, press
active Destination, and the name of that Source will appear in the
Destination window, in green.
Breakaway takes of individual levels can be accomplished either by de-
selecting the level(s) that you do NOT want to switch, or by choosing which
levels that you DO want to switch. Whatever method is used depends on
the panel's
Level Select
Level Select mode on the LD4 panel is set via the menu:
1. Press the
button. The windows will display various configuration
Menu
modes. Press the
Up/Down
window (D3). It will report its current setting, either
JUPITER L-S and LCD Series Control Panel Instruction Manual
soft button for the D4 window.
Select Source?
in white. Sources will appear in
Source?
111).
. The Source will be switched to the
Take
mode setting.
arrow buttons to display the
Level Select
or
ALL ON
ALL OFF.
Advertisement
Table of Contents
