Table of Contents
Advertisement
To Execute an Override
Sequence (Salvo) Switching on an LD16 Panel
Front-Panel Service Modes
JUPITER L-S and LCD Series Control Panel Instruction Manual127
in which the overrides are listed on the CP Override set table will be the
order in which they appear on the panel.
1. Select the desired Destination.
2. Press
. The D1window will display
Override
windows will indicate available overrides. To scroll to additional
override groups, use the
3. Press the soft button next to the desired override.
4. To execute the override switch, press
specified in the override will be switched to the Destination.
Pre-built Jupiter sequences can be executed after they have been created
and downloaded (see Setting Up a Salvo with a Sequence Set
1. Press the
button. Sequences will appear in groups of 16, in white, in
Seq
the display windows. Use the
additional sequences.
• If the
button does not illuminate, there may not be any
Seq
sequences defined to this panel.
2. Press the soft key for the desired sequence. The number of the preset
sequence will appear in the D16 window.
3. Press
Take
to execute the sequence.
These modes are provided for panel maintenance and troubleshooting.
They are not normally used by the operator.
• Panel Info Mode is described on
• Panel Setup Mode is described on
Select Override
arrow buttons.
Up/Down
. The Sources on the levels
Take
arrow buttons to scroll to the
Up/Down
page
185.
page
187.
LD16 Control Panel
. The display
on page
62).
Advertisement
Table of Contents
