Table of Contents
Advertisement
Installation Instructions
Hardware Installation
JUPITER L-S and LCD Series Control Panel Instruction Manual
The following instructions will guide the customer in the installation of the
GPI/O accessory. The Installation procedure will require you to remove the
protective cover and then install the GPI/O in place of the cover.
To add the GPI/O to the S, L, or LCD control panel:
1. Remove the four screws (two on top and two on bottom) from the
panel.
Figure 97. Location of the Four Screws
2. Remove the cover from the back.
Figure 98. The Back Cover
Remove the screws
Remove the cover
Installation Instructions
191
Advertisement
Table of Contents
