Source Swap Mode (Ld4 Panel); Overrides (Ld4 Panel); To Execute An Override - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Source Swap Mode (LD4 Panel)

Overrides (LD4 Panel)

To Execute an Override

JUPITER L-S and LCD Series Control Panel Instruction Manual117
If the Source Swap mode has been turned ON, the display windows will
preset to the previously-selected Source, shown in Blue after each Take.
This permits flip-flop switching on the LD4 panel using just the
1. Press . The display windows will display various modes.
Menu
2. Use the arrow buttons to display
Up/Down
and press its soft button.
3. The menu will be displayed in the D2 window with its
Source Swap
current status (ON or OFF).
4. Press to toggle the state ON or OFF.
Take
The panel will exit Menu mode and operate with the new state.
Overrides can be used for a quick or emergency switch to an often-used
Source and level combination. For example, the black burst generator could
be defined as the first "override" Source for a particular control panel, cor-
responding to the first override soft key position. Override names can be
customized if desired. Each override can be configured to switch any
desired combination of router levels. The order that the overrides are listed
on the CP Override set table will be the order in which they appear on the
panel.
1. Select the desired Destination.
2. Press , use the Up/Down arrow buttons to display
Menu
the D2 window and press its soft button.
3. The display windows will indicate available overrides. To scroll to
additional override groups, use the
4. Press the soft button next to the desired override.
5. To execute the override switch, press
specified in the override will be switched to the Destination.
LD4 Control Panel
in the D4 window
Panel Config?
Select Override
arrow buttons.
Up/Down
. The Sources on the levels
Take
button.
Take
in