Table of Contents
Advertisement
Executing a Sequence (Salvo)
Direct Execution
Direct Execution with Preset
Menu Execution
Source Swap Mode
JUPITER L-S and LCD Series Control Panel Instruction Manual107
After a sequence is created and downloaded (see Setting Up a Salvo with a
Sequence Set
on page
62) it can be executed as follows:
In order to directly execute a sequence, that must be assigned to a panel
button (see Button Assignment
1. Press the assigned Sequence button for the desired sequence.
All the Destinations in the sequence will immediately be switched to their
designated Sources.
Preset allows you to select a sequence assigned to buttons and identify it by
name before executing it.
1. Press
so it is illuminated.
Preset
2. Press the low amber button for the desired sequence. The sequence will
NOT execute. Instead, the
the sequence will be displayed on the menu. Different sequences can be
selected with their assigned buttons until the correct one is found.
3. Press
. That sequence will execute and all the Sources will be
Take
switched to their Destinations.
4. To exit Preset mode, press the
1. Press the
button. The Status/Destination window will display
Menu
configuration modes.
2. Use the
arrow buttons to scroll to
Up/Down
3. Press
. Sequence names will appear in the Status window.
Take
4. Use the
arrow buttons to scroll to the desired sequence.
Up/Down
5. Press
. All the Destinations in the sequence will be switched to their
Take
designated Sources.
Turning on Source Swap mode allows rapid permits flip-flop switching
between two Sources. The last selected Source is retained (displayed in
on page
108).
button will illuminate and the name of
Take
button so it is turned off.
Preset
Select Sequence?
L32/L64 Control Panels
mode.
Advertisement
Table of Contents
