LCD Hardware Installation
Rack Mounting
Power Supplies
JUPITER L-S and LCD Series Control Panel Instruction Manual157
This section describes hardware installation procedures for the LCD series
hardware panels.
Jupiter LCD panels mount into a standard 19 inch equipment rack. Panels
are 1 or 2 rack units high.
Two methods are available for powering the LCD series hardware panels:
• AC power supply (JUP-ACPS)
• DC power supply (JUP-DCPS)
The module used is specified at the time of order.
All power modules are auto-sensing (120-240 VAC, 50-60 Hz) and are sup-
plied with a mains power cable appropriate for the user's geographic loca-
tion. No power switch is present. The AC cord is disconnected to power
down the panel.
WARNING
Do not connect any external power supply other than the approved "JUP-
DCPS" unit supplied by Thomson Grass Valley.
The AC power supply is contained in a module that mounts on the rear of
the panel (Figure 84).
8
Section