Sticky Levels Mode
LD16 Multiple Destination Mode
Entering Multiple Destination Mode
JUPITER L-S and LCD Series Control Panel Instruction Manual123
2. Press the
button so it is illuminated. All levels will be deselected
LEVEL
and their soft buttons will turn off.
3. Toggle ON the soft button corresponding to the level(s) to be switched.
To move beyond the first 14 levels, use the
4. Select a Source using one of the methods described under Selecting a
Source (Single Destination Mode)
5. Press
. The Source will switch only on the selected levels, while the
Take
non-selected levels will remain at the previously selected Source.
6. The level windows will indicate status of the first 14 levels of the
switcher.
• If Sticky Levels is off, after the Take all levels will automatically be
deselected (their buttons will turn off). If Sticky Levels is on, only
the levels involved in the last Take will remain selected.
If Sticky Levels mode is ON, the level(s) involved in a breakaway Take
remain selected for subsequent Takes. To turn on Sticky Levels mode:
1. Press
. The display windows will display various modes.
Menu
2. Press the
Panel Config?
displayed with its current status (ON or OFF).
3. Press
to toggle the state ON or OFF)
Take
Multiple Destination mode (sometimes referred to as "multi-bus" mode) is
in effect when various Destinations, in yellow, appear in the D1-D16 win-
dows; and level names ("video" etc.) do not appear.
This mode displays the top level (For example, video) status for 16 Desti-
nations. Additional pages of Destinations each can be accessed using the
arrow buttons. Multiple Destinations can be selected for single-
Up/Down
Take switching.
1. Press
. The display windows will display various modes.
Menu
Up/Down
on page
120.
soft button. The
Sticky Level
LD16 Control Panel
arrow buttons.
menu will be