Basic Panel Operations; Taking A Source To A Destination (Take); Advise Router Option; Destination Protection - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Basic Panel Operations

Taking a Source to a Destination (Take)

Advise Router Option

Destination Protection

Destination Locking

JUPITER L-S and LCD Series Control Panel Instruction Manual97
The most basic operation of any router control panel consists of selecting a
router Destination, followed by selecting a router Source. This connects the
router Source input signal to the router Destination output.
When the Advise flag option has been set in the Jupiter Control system and
an attempt is made to switch control to a new device, the switch will not
occur. The system will instead display the following message on the control
panel in two lines:
SRC in use
by: <Destination name>
The switch to a new device will not be executed until the destination that is
using the source is either:
• Switched to a different source.
• Switched to the "SAFE" input.
Note The Advise and Enforce options do not work when you are using Sequences
or Multiple-destination switching when the same source is being routed to
more than one destination.
This option will avoid having the control device connected to two
machines at the same time.
Protecting a Destination prevents that Destination from being switched by
other panels in the system. The protecting panel may still change the Des-
tination. If any selected Destination's level is protected, the
button LED on that panel will illuminate amber. If any level is locked by
that panel, this panel's
Locking a Destination prevents that Destination from being switched by
any panel in the system, including the initiating panel. If any of a Destina-
tion's level is locked, the
nate red. If any level is locked by that panel, this panel's
will blink amber.
LED will blink red.
Lock/Protect
button LED on that panel will illumi-
Lock/Protect
Introduction
Lock/Protect
LED
Lock/Protect