Changing Between The Normal And The Sticky Level Modes - GRASS VALLEY JUPITER L - V2.1.0 Instruction Manual

Changing Between the Normal and the Sticky Level Modes

JUPITER L-S and LCD Series Control Panel Instruction Manual131
With Sticky mode, the S25/S50 panel will retain the last selected levels that
were selected even after the source take occurs.
Normal or Sticky Level mode will be retained after a power cycle.
Follow these steps to change the S25/S50 panel between the Normal and
the Sticky level modes:
1. Press the first left two vertical button pairs that are part of the group of
eight level buttons at the same time.
2. Hold both buttons down for approximately three seconds.
• Changing from Normal to Sticky level mode, All configured level
button led's will change to Low Tally state. This indicates that the panel
is now in Sticky level mode. All Source button led's will also change to
Low Tally state to indicate there is no status available for the destination
because NO levels are selected.
• Changing from Sticky to Normal level mode, All configured level
button led's will change to High Tally state. This indicates that the
panel is now in Normal level mode. If a take has occurred to the desti-
nation that included the first level in the configuration, then the corre-
sponding Source button led will change from Low Tally to High Tally
state.
Both buttons MUST be released, then pressed again to change between
Sticky and Normal level mode again.
S25/S50 Control Panels