Table of Contents
Advertisement
JUPITER L-S and LCD Series Control Panel Instruction Manual171
Setting levels for a breakaway switch
Follow these steps to set levels for a breakaway switch:
1. Press the Scroll wheel to go to the Main menu.
2. Press the
Level Mode?
3. Select the preferred Destination. For steps to select a destination, see the
Select Destination Mode
4. Press the preferred level button(s), that would correspond to the levels
required for the breakaway switch. The selected level buttons will then
turn white. Press the preferred
will then turn white.
5. Press the
Select Source
6. Select the preferred Source. The panel will automatically return to the
Level menu. The
Level
any, on line 2 and the preset source (the one just selected) will be
displayed on line 1. For more information about button lines see the
Standard Button Display
7. Press the
button. The selected buttons will now return to amber
TAKE
and the switch will then occur. The active Source is now displayed on
line 2 of the button.
The Level mode also supports "Sticky Levels." When the Sticky Levels
feature is enabled (or turned on), the previously selected levels will remain
selected after a Take is preformed.
Note
If "Sticky Levels" is NOT turned on, then the selected levels will automatically
be de-selected when the take button is pressed.
Setting all Levels On or OFF
The ability to quickly turn all levels on or off with a single button push is
offered in this mode. The
tons. The
button is #11 on the LCD16 and #31 on the LCD47. To
Set All levels
select a specific level, press the preferred Level button.
The purpose of the
Select All levels
the levels on (or all the levels off) with a single button press. For example,
to switch all the levels except for the first level, you would press the
button to select all the levels. Then you press the first level button
Levels - ON
to de-select it. All levels have now been selected, except for the first level,
in two button presses.
The following instruction describe how to set all levels on or off in more
detail than the example above. These instructions assume that the Level
mode has already been selected and that all levels are off and are amber.
button.
section. The selected output will be displayed.
button. The selected level buttons
Levels
button, the Source menu will then appear.
button will have the currently selected Source, if
section.
button will select or deselect all but-
Set All levels
button is to give you a fast way to turn all
Basic Panel Operations
All
Advertisement
Table of Contents
